Camec’s New European designed Instantaneous Water Heater system is an economical solution for RV’s to supply constant hot water. Unlike 240V systems that draw massive current, clever design of this system means it can operate for many hours at maximum heating capacity from just one 9kg gas bottle! The digital controller gives you flexibility to set your desired water temperature plus peace of mind knowing the water temperature can be controlled so it will not be too hot for children.
One of the key benefits of an RV instantaneous water heater is that gas is only used when water flows (the water heater is activated by the initial flow of water through the system). In other storage tank systems, energy is required on a continual basis to keep the water stored at the desired temperature and with an Instantaneous system, you are able to use all of the available water in your RV’s storage tank (with a storage system, you can’t use the remaining stored water if the RV’s water tank is empty).
The remote digital display not only allows you to set your desired water temperature, it also can turn the unit on an off; displays the current water temperature as the water is flowing plus it displays system error codes when required for simple problem solving. Also features: Low power and gas usage, system stores the last selected water temperature setting even when powered on and off, digitally monitors incoming water temperature, water flow and output temperature.
NOTE: Water temperature depends on flow rate. The higher the flow rate, the lower the water temperature. This unit is designed to increase the water temperature by approximately 37C, at a flow rate of 3.3 litres per minute and is recommended to be used in conjunction with a low flow shower head. It is not designed to be connected to mains water pressure or used with a high flow pump or shower head. This provides an important water and gas saving feature, especially suited to free camping.
Australian and New Zealand AGA Gas Approval Certificate no: 8208-02, Watermark Approval WM-022656
NOTE: Installation of this product must comply with the requirements of AS/NZS 3500.4
Installation and service must be performed by a qualified installer, service agency or OEM
|Capacity||Water temperature rise of approximately 37oC at 3.3 liters per minute. Higher flow rates will result in less temperature rise|
|Dimensions||Installation cut-out dimensions: 320mm (w) x 320mm (h) x 380mm (d)|